1 Solar Charge Controller 3KW User Manual www.ADVICE.co.ile-mail:[email protected]
10 The RTS cable may be pulled through conduit along with the power wires. Tighten the connector screws with 5 in-lb (0.56 Nm) torque. NOTE: The RT
11 A battery voltage sense connection is not essential required to operate your controller, but it is recommended for best performance. The battery
12 Insert bundled software CD into a computer and follow on-screen instruction to install the monitoring software. For the detailed software
13 4. OPERATION 4.1 Power-Up WARNING: Risk of Damage Connecting the solar module to the battery connector will permanently damage the controller.
14 Operation Button Function Action Description Power on Press the button until LCD backlight is on. Enter Press the button for 5 seconds until it
15 Indicate charging current. Indicates battery level by 0-24%, 25-49%, 50-74% and 75-100% in battery mode and charging status in line mode. Batt
16 4.3 Charging Current Setting After pressing and holding the button for 5 seconds, the unit will enter setting mode. Only charging current is able
17 5. TROUBLE SHOOTING Situation Solution Fault Code Fault Event 01 Over charge current 1. Restart the charger. 2. If the problem remains, please c
18 6. SPECIFICATIONS Table 1 Electrical Specifications MODEL MPPT 3KW Nominal System Voltage 12, 24, or 48 VDC Maximum Battery Current 60 Amps Maximu
19 Charging Set points Absorption Stage Float Stage Flooded Battery 14.6V / 29.2V / 58.4V 13.5V / 27V / 54V AGM/Gel Battery 14.1V / 28.2V / 56.4V 13
2 CONTENTS 1 ABOUT THIS MANUAL ... 3 1.1 Purpose ...
3 1 ABOUT THIS MANUAL 1.1 Purpose This manual describes the assembly, installation, operation and troubleshooting of this unit. Please read this ma
4 2 INTRODUCTION Thank you for selecting this solar charge controller. This solar charge controller is an advanced solar charger with maximum power p
5 2.2 Product Overview 1. LCD display 2. Power On/Charging indicator 3. Fault and warning indicator 4. Wiring fault indicator 5. Operation bu
6 3. INSTALLATION 3.1 Unpacking and Inspection Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. You
7 Install the unit to the wall by screwing four screws. Refer to right chart. 3.4 Power Connection Wire size The four large power terminals are si
8 Connect the Power Wires WARNING: Shock Hazard The solar modules can produce open-circuit voltages in excess of 100 Vdc when in sunlight. Verify if
9 to the controller. 4. Connect positive terminal (+) of battery to the battery positive terminal (+) on the controller. 5. Connect negative termi
Commentaires sur ces manuels